The root password is tslinux by default, but if it has been changed then you can boot the unit into single user mode by supplying the argument single to the Linux kernel selection during the boot process (make sure you put a space between the existing Kernel parameters and single) which will drop you to a root prompt.On my unit, this line comes up as right at the start of the boot process: LinuxPPC load: rootdevram ramdisk0x0001F000 So you would type single (remember the space) to give you: LinuxPPC load: rootdevram ramdisk0x0001F000 single Then just hit enter and the unit will boot up into single user mode and give you the root prompt.At this point, if you want to restore the entire unit to the factory default settings which will erase all of the configuration, then just run defconf and then reboot the unit.
Cyclades Acs48 Firmware Password Is TslinuxIf you want to keep the existing configuration intact but just reset the password then you can just use the traditional Linux passwd tool to edit etcpasswd: root(none) passwd New password: Re-enter new password: Password changed root(none) saveconf Checking the configuration file list Compressing configuration files into tmpsavingconfig.tar.gz done. Saving configuration files to flash done. This action is irreversible and the device must be rebooted to apply that. Are you sure you wish to continue (yN) y bindefconf: mntflashconfig.tgz: Read-only file system root(none) I cannot even set factory default. Did you follow the instructions to boot into single user mode Edward Log in to Reply. Pingback: Avocent Cyclades ACS48 Console Server Greg Sowell Consulting Leave a Reply Cancel reply You must be logged in to post a comment. Prev Post Cisco DHCP snooping with a Cisco DHCP relay (ip helper) and DHCP option-82 Next Post Using kill to display dd progress Spheron1 About Contact Spheron1 recent blog posts.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |